Appliance Installation Bookings: Access Checks Before the Van Leaves
Short answer: Failed installations are mostly not about the appliance. They are about a corridor that is narrower than the box, a missing water shutoff, a power outlet in the wrong place or a customer who thought you would remove the old unit. Seven mistakes cause most of them. Each has a fix that lives in the booking form or the confirmation message, and each costs a few minutes to build compared with the cost of a second trip.
This article is about the installer's side of the job: firms that deliver and connect washing machines, dryers, dishwashers, ovens, cookers, fridges and similar items, whether for a shop, a landlord or direct customers.
Mistake 1: Measuring the appliance but not the route
Customers check whether the dishwasher fits the gap under the counter. Few check whether it fits through the front door, up the stairs, round the turn at the landing and into the kitchen.
Fix: Ask for the narrowest point on the route, in centimetres or inches, with a diagram. Provide three tick boxes: stairs, lift, or ground floor. For stairs, ask about turns and low ceilings. Compare the answer against the appliance dimensions, which you already know from the order, and flag a mismatch before you confirm the slot. If the customer cannot measure, ask for a photo of the entrance and the stairs.
Mistake 2: Forgetting the space where it will sit
An integrated dishwasher needs a certain gap. A freestanding oven needs clearance on the sides. Fridge doors need room to open.
Fix: Ask for height, width and depth of the space, and whether the cabinet or worktop above is fixed. For a built-in unit, ask for a photo of the gap and whether the old appliance is built in or freestanding. Add a short line that the installer will not alter cabinetry unless it is part of an agreed service.
Mistake 3: Assuming the connections exist
Water, drain, power and gas are four separate checks.
Fix: Turn them into a short checklist the customer can answer at the machine:
- [ ] Cold water supply tap with a free outlet (and hot, for those models that need it)
- [ ] A drain standpipe or a spigot under the sink
- [ ] A power socket within reach, not behind the unit
- [ ] A gas supply with a shutoff valve, for gas appliances
Do not describe regulations for gas connections or electrical work. Requirements for who may connect gas or hard-wired items are set by the local authority or licensing body, so state your own rule, such as "gas hookups are done by our licensed technician only", and refer customers to the official body if they want more detail.
Mistake 4: Leaving the old appliance as a surprise
The customer assumes you will take the old washing machine. The installer assumes it will be in the driveway. Both are annoyed.
Fix: Ask explicitly: "Do you want us to remove your old appliance?" with options for yes, no and "not sure". Say whether there is a fee, and say whether you remove it only from the ground floor. Disposal and recycling rules differ by region, so keep the page factual and let the customer confirm a quote.
Mistake 5: Offering exact times you cannot keep
Installations depend on traffic, previous jobs and surprises in a basement. An exact arrival time looks decisive and fails often.
Fix: Offer a window, such as a morning or afternoon block. On the day, send a message when the previous job is nearly done, and again when the installer is on the way. A small table in your admin view helps:
| Time block | Jobs booked | Max jobs | Notes |
|---|---|---|---|
| Morning | 3 | 4 | One stair carry |
| Afternoon | 2 | 4 | Cooker job, allow extra |
Give jobs with stairs or gas connections more time so the day does not slip.
Mistake 6: Treating the installer as a delivery driver
If a customer ticks "delivery only" and then expects you to plumb in the machine, you have a dispute. The reverse happens too.
Fix: Make the service level a clear choice on the first screen:
- Delivery to the door
- Delivery to the room
- Delivery and installation
- Installation of an appliance bought elsewhere
State exactly what each includes in plain sentences. Many firms list what is not included, such as new pipework, cabinet changes or repairs to old connections.
For option 4, add a question about where the appliance was bought and whether it is in its box. If a customer's own machine arrives damaged or incomplete, you need that line on file.
Mistake 7: No pre-visit confirmation
The booking was made two weeks ago. The customer has since moved the furniture, cancelled the plumber or forgotten the parking permit.
Fix: Send a short confirmation two days before and ask three things:
- Is the access route clear and the space ready?
- Can we park near the door, or is a permit or building contact needed?
- Is there anything new, such as a different appliance model?
Include a button to rebook if they are not ready. A cancellation announced two days ahead is far cheaper than a refusal at the door.
For apartment buildings, add fields for lift booking, loading dock hours and a building manager's contact. A short note saying that deliveries may need a booked lift or a deposit to the building is helpful, but leave the details to the customer and the building.
What to record after the job
Store photos of the final installation, the model and serial number, the date and the connection details. If a leak appears a week later, the record shows how the machine was connected. If the customer disputes damage, it shows the state when you left. Ask the customer to confirm the result by tapping a link, and keep the confirmation time.
Findability
Local search plays a large part. List the appliances you install, the areas you cover and the service levels above, and keep your business details identical on the site and in your listings.
FAQ
Should customers be required to be home?
Yes for installation, as a person must show the space, sign off the work and receive instructions. For delivery to the door only, you can offer a safe-place option if your policy allows it.
What if the appliance does not fit?
Decide the policy in advance: refund of the installation fee, a restocking arrangement, or a rebook. Put it in the terms the customer sees before booking.
Do we need the model number on the form?
If you did not sell the appliance, yes. It tells you dimensions, connection types and whether it needs special parts.
How early should reminders go out?
One at booking, one a couple of days before and one on the morning of the job is enough. More than that feels like noise.
If your installation team is losing time to second trips, we can build the booking form and confirmation flow that catches these problems early, so tell us about your jobs.